On this page you'll learn how to do your own estimate for hurricane shutters,            screen enclosures and aluminum roofs.  The prices have dropped, so act now before            they go up again in January 2018.

Hurricane shutters:

Accordions:

For High Velocity = \$12.50 a square foot

1. You'll need these tools: Clip board and a sheets of paper, pen and pencil and calculator.

2.  Do a plan sketch of all the openings you want covered. mark them all clockwise # 1 through as many
openings as you have.  If you have more than one story, do two or three sketches, one per floor and
mark openings the same way.

3.  Measure each opening that you have numbered. mark next to the marked opening, first the width and
then the height in inches.

4.  Once you have measured all, get a separate sheet of paper and list out all of your opening sizes on
the left side of the page. Leave yourself room to the right of the measurement. you're ready for step:

5.  Calculate the square footage of each opening, one by one.
height
. Multiply the width by the height (in inches).
Divide by 144 and you'll get a result. This is the square footage of the opening. mark this next to the size.

6.  Continue doing the same procedure per opening. Each new opening and measurement will now be in

8.  At this point you're wondering what we charge a square foot. It is as follows: For a simple installation it's
about \$13.00 a square foot. So multiply your total square feet by \$12.50 and you have a rough price. If your
house is 2 stories, add about \$35 per opening on second floor only.

Roll up shutters:

1. Do steps 1-4 above

2. Add 8" to the width and about 12" to the top (this will be taken up by the box. If your opening is only up to
51" high, only add 9 inches to the height. Multiply in inches and then divide by 144. Now you have the
square footage.

3.  Do the same for each opening.

4. Add up your square feet and multiply by \$30 a square foot ( I know that's a lot...but that's installed and
that's what it is).

5. If your opening is bigger than 35 square feet, like a door or bigger, you'll need a motor. These cost about
\$500 more per opening.
6. Add all of it up including motors.
Screen Enclosures:

1.  Draw a sketch of your project. I usually just do a 3 dimensional drawing, showing your sides, front and roof
area, indicating how high you want to go.  Most screen rooms are about 8 feet high. Mark your side wall
as area number 1, front wall as area number 2, the other side wall as area number 3 and your roof area as
number 4.

then 2, then 3 and then 4. Measure width first and then height (don't ask me why we do it like that. We just
got used to it and it's a standard in the industry).

3.  Add area one, then 2 and so on. You now have the total square footage. Multiply by \$5 per square foot.
That is what most companies charge. When you have a large area, such as bigger in depth than 20 feet,
multiply the roof area only by about \$7 a square foot. Depending on the engineering, the beams could be
quite big that span across the roof area and are more costly.

Well, now you know what we do and go through to give you an estimate. Yes, it requires a bit of work and
using one's head.  Sometimes the hot Florida sun can make this a bit arduous. We don't mind it too much.
You could say we're used to it. But we don't appreciate it when some clients make us jump through hoops to
get us to give them an estimate and then forget about us completely. I mean, not even a courtesy call to let
us know that they got a bit for about \$100 less. That's cold, you know.

Anyway, I know you're not going to do that.  I also know you may appreciate me giving you some trade
secrets.  My competition may cringe at the fact that I'm sharing some of them with you. So be it. Knowledge
should be shared for free most of the times. What do you think?

I hope this was helpful. It is by no means complete. There are other factors that play in, such as difficulty of
job, accessibility, etc. You also have building permits to consider as well as building plans, engineering and
City fees. These all vary.

bettershutters.com

Beautiful pyramid shaped Pool Enclosure

Call: 305 266 2100

Call today

305 266 2100

We have thousands of satisfied

customers

Our facilities in Miami

We accept:

Screen Porch and nature

Rear Screen Porch

<SCRIPT language="JavaScript" type="text/javascript">
<!-- Yahoo! Inc.
var ysm_accountid  = "1DULJJVQ2DH69BJDABH7UGHLS4C";
document.write("<SCR" + "IPT language='JavaScript' type='text/javascript' "
+ "SRC=//" + "srv1.wa.marketingsolutions.yahoo.com" + "/script/ScriptServlet" + "?aid=" + ysm_accountid
+ "></SCR" + "IPT>");
// -->
</SCRIPT